1. Slide the back panel of the P400 off and attach the cord to the device. It should resemble the image below.
If you received a different cord notify Rent It Biz Support.
2. Once the chord is attach to the P400 plug a network cable into the ETH port. The network cable must be
connected to the to a modem or switch that belongs to the same network as the computers running
Rent It Biz.
3. Plug in the power cord. The screen should light up and take a few seconds to load. If your device is
plugged to your network correctly it should also display an IP address. When it is done loading, the
screen will display Point Welcome.
